Cable Tray Hangers

Places a hanger family along every selected cable tray, at the spacing you set.


Publisher
Software
Revit
Category
Building MEP
Discipline
Electrical Systems
Tags
#BIM #MEP

Description

Cable Tray Hangers places the hangers of a cable tray run for you. Select the cable trays, pick the ceiling or floor face that carries the hangers, set the spacing, and the add-on places one hanger family after another along each tray.

  • Takes the cable trays from your selection and shows how many trays and what total length you picked.
  • Places the hangers at the spacing you type, along the line of each tray.
  • Turns each hanger to the direction of its tray, also when the tray is sloped.
  • Reads the width and the height of the tray, and writes them into the hanger, plus the tolerance you set on each side.
  • Writes the hanger elevation and the anchor elevation from the face you pick.
  • You name the family parameters for width, height, centre elevation and anchor elevation, so the add-on works with your own hanger family.
  • Removes a hanger it could not set, so no half-finished hanger stays in the model.
  • Works in Revit 2020 to Revit 2026.

Ratings

No ratings yet

Trust me, I've looked everywhere, there's nothing here :(