BOSP

Writes the bottom of pipe elevation at the start and the end of every pipe, in ft, m and mm.


الناشر
البرمجيات
Revit
الفئة
Building MEP
التخصص
Plumbing Systems
العلامات
#MEP #BIM #BOSP

الوصف

BOSP writes the bottom of pipe (BOP) elevation on every pipe in the model, with one click. Use the values in tags and schedules for drainage and plumbing drawings.

  • Adds six shared parameters to the pipes: SBOP (ft), SBOP (m), SBOP (mm) for the start, and EBOP (ft), EBOP (m), EBOP (mm) for the end.
  • Writes the parameters into your shared parameter file when they are not there yet.
  • Calculates each value as the middle elevation at that end of the pipe, less half the pipe diameter.
  • Rounds feet and metres to 3 decimals, and millimetres to 1 decimal.
  • Updates every pipe in the model in one run. Run it again after you move pipes to refresh the values.
  • Stops with a message when Revit has no shared parameter file set.
  • Works in Revit 2020 to Revit 2026.

التقييمات

لا توجد تقييمات حتى الآن

ثق بي، لقد بحثت في كل مكان، لا يوجد شيء هنا :(